In the next several days, I expect to see some terrific results. I have planted grass seed and have done some overseeding as well. When you are committed, anything is possible. I was anxious but, in the end, I was able to finesse everything into its proper place. Also, one of the outer panels was not square leaving me with a 1/8″ smaller span than was necessary. I was able to replace the missing parts without having to call the company and wait for 3 weeks. In short, the assembly of this product, for me, was somewhat more difficult than was shown in the videos, a few minor parts were missing (3 pairs of nuts and bolts that were meant to be used on a center brace for the aerator axle) but workable. I put down some Lesco Starter Fertilizer afterward and watered it in (about 30 minutes of watering per zone) just to be sure that the fertilizer stuck to the soil and wouldn’t be washed away in the next storm. I performed the aforementioned criss-cross pattern while operating to complete a thorough job. I went out and made my damp soil attempt and the machine worked amazingly well.Īs mentioned, the soil was successfully aerated to a depth of 2 – 3 inch by 3/4 inch wide holes. It was to rain that night, so I waited for a day. I read later on that aeration is best done when the soil is damp. Unfortunately, the ground was dry (hadn’t rained in quite some time). Still, a fine job was done.Īfter picking up all the dead thatch, I did a very quick replacement of the dethatcher with the core aerator attachment and proceeded to aerate a portion of my yard that wouldn’t be seen by the neighbors. It is essentially traversing in a serpentine pattern to overcome the tractor wheels spinning due to the weight of the dethatcher. However, in the front yard, there is a bit of an incline that had to be compensated for by way of snaking the hill as I call it. I will say that, for the most part, my lawn is flat. Bags and bags of thatch had been pulled up leaving a good portion of the actual soil exposed. While a bit trepidatious, I found that the dethatcher did a fine job. Sears, who used to own the Craftsman name used to license most of their manufacturing to Black and Decker for decades… my lawn tractor, a Craftsman (Bought while Sears still owned the name) was made by Husqvarna widely considered to be the top name in that sort of equipment. I can only assume that John Deere is keeping a close eye on Agri-Fab to keep to the JD standard. It seems fair for me to tell you here that, as it turns out, they are both manufactured by Agri-Fab… I know What?!?! I didn’t find this out until the box showed up on my driveway with a label that mentions that fact in small print. From the subjectively ostensible (pictures and videos), the John Deere model seemed to have better hardware all the way around, albeit being a little more expensive. John Deere had none of these stories highly rated. It did have 4 stars (respectable, for sure) on Amazon but, just the wheels alone made it look like a toy by comparison. Frankly, the Agri-Fab model (Agri-Fab SmartLink) ratings told several repeated stories of horrendous experiences where buyers had wheels coming off their units and the like. I chose the John Deere as it had far better ratings than the Agri-Fab model. There were only two manufacturers I had found that we were able to make the same offering: Agri-Fab and John Deere.I figured the last 2 – 3 inches apart where the core aeration axle placed the blades about 5 – 6 inches apart, could be compensated for with usage by way of a criss-cross pattern approach usage. The product I purchased covered the first two aspects nicely. After researching, I found that Briggs and Stratton, one of my most trusted authorities, recommend looking for an aerating tool or machine that removes soil plugs approximately 2 - 3 inches deep and 0.5 - 0.75 inches in diameter, and about 2 - 3 inches apart.I wanted not to have to suffer the cost of renting and to be able to accommodate the necessary storage space in which to keep the accessory. I chose this product mostly because it had both the aerator and dethatcher facilities.I wanted to write a review of this product from a real owner’s experience and not just some blog where the writer hasn’t even laid eyes on it and is just out for a commission. After doing the research, I bought a John Deere Plug Aerator with Dethatcher. My lawn has been in serious need of both dethatching and core aerating for a couple of years. The John Deere 40″ Plug Aerator/DethatcherĪs a DIY guy, who would rather do it himself than pay “The Man”, I bought this tool out of real necessity.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |